1967 PLYMOUTH BARRACUDA

LED CONVERSION INSTALLATION INSTRUCTION

It is always recommended to remove the taillight assembly from vehicle when installing new LED conversion kit, but with a little more effort LED can also be installed with the taillight on the car.

1- Disconnect negative battery cable

2- Remove taillight lens, and bulb

3- Install new aluminum sleeve from the backside of taillight (threaded part in)

4- Place one ¼≤ aluminum spacers over threaded part of the sleeve

5- Place new bracket vertically over the spacers, then install new mounting nut, and tighten nut with a needle nose pliers.

6- Connect LED bayonet to the original socket thru the taillight hole, and connect socket to the sleeve. NOTE: MAKE SURE LED WIRES ARE GENTALY PLACED IN THE HOUSING

7- Place LED board on the bracket, and with the two 4-40 ½≤ bolts provided in the kit tighten LED

8- Reinstall lens assembly , and connect battery cable

9- Inspect all taillight functions before driving